Filter
Top Products
11
Mounting the Flange and Paper Tube
When using the core from used-up rolled material as the paper tube
When mounting the paper tube on the flanges, make sure that
the paper tube fits snugly. Attempting to take up material when
the paper tube is not stable may cause problems such as the pa-
per tube coming loose. The outer diameter of the flange portion
where the paper tube is fitted is shown below.
Sheet
Pull out the stopper.
1
Align the flange with the
groove on the shaft, and press
in all the way.
2
Insert the stopper.
3
Mount the paper tube.
5
Follow steps 1 to 3 to mount the
flange for the frame as well.
4
Tighten the mounting screws securely.
6
Make sure the margin described below is present between
each flange and the edge of the material. Attempting to take up
material when no margin is present may cause the material to
touch the flange and result in faulty take-up.
Side view of flange
Paper tube
20 mm (13/16 in.) or more
FlangeFlange
7. Loading Material
Do not attempt to change a roll
material while the power remains
switched on.
The take-up motor may be activated
unexpectedly while changing the roll,
leading to injury. The power must be
switched off before attempting to change
the material.
Roll material must be placed at a
predetermined shaft position.
Failure to do so may allow the material to
fall, leading to injury.
* For detailed informa-
tion on loading
material, please refer to
the CJ/FJ user's
manual.
When in the manual mode, make sure there is some slack in the material before attempting to perform take-up.
NOTICE
76.2 mm
(3 in.)
50.8 mm
(2 in.)