Filter
Top Products
Controls and Functions
Runco PL-43DHD and PL-50DHD Owner’s Operating Manual 7
PRE
L
IMINAR
Y
1. EXTERNAL SPEAKER OUTPUT (RIGHT)
Not used. Connect speakers to an external audio amplifier/receiver.
2. COMBINATION IN/OUT
Used to control multiple PlasmaWall monitors collectively. Use a 6-pin, mini-DIN cable
(all pins wired straight-through).
3. RS-232C (9-pin, male D-Sub)
Connect the RS-232 OUT port on the DHD Controller to this input.
4. ANALOG RGB IN (INPUT 1) (15-pin D-Sub)
Connect the RGBHV (5xBNC) output from the DHD Controller here.
5. ANALOG RGB OUT (INPUT 1) (15-pin D-Sub)
If desired, connect this ouput to the RGB input of a second display device.
6. AUDIO (INPUT 1) (3.5-mm stereo mini jack)
Not used with this model. Connect the audio outputs from your sources to an external
audio receiver.
7. DIGITAL RGB (INPUT 2) (DVI-D)
HDCP-compliant digital video input. Connect the DVI output from the DHD
Controller to this input.
8. AUDIO (INPUT 2) (3.5-mm stereo mini jack)
Not used with this model. Connect the audio outputs from your sources to an external
audio receiver.
9. AUDIO (OUTPUT) (3.5-mm stereo mini jack)
Not used with this model.
10. MAIN POWER SWITCH
Connects or disconnects the PlasmaWall from the AC power source.
11. POWER INPUT (100 to 240 VAC)
Connect the PlasmaWall to power here, using the included power cord.
12. EXTERNAL SPEAKER OUTPUT (LEFT)
Not used. Connect speakers to an external audio amplifier/receiver.
This output is not active when the PlasmaWall is off or in standby
mode.
Note