Filter
Top Products
Installation
20 PlasmaWall SP Series Owner’s Operating Manual
PRE
L
IMINAR
Y
3.3
Installation
Considerations
Proper installation of your PlasmaWall will ensure the highest possible picture quality.
Whether you are installing the PlasmaWall temporarily or permanently, you should take the
following into account to ensure that it performs optimally.
High-Altitude Operation Due to the design of all plasma glass panels made by every manufacturer, and the
interaction between ambient air pressure and the plasma gases contained inside of the
panel, reliable operation of your plasma display cannot be assured during operation at
certain high-altitude locations.
Runco has found the SP-42DHD, SP-50DHD and SP-60DHD to operate reliably at
altitudes of up to 6000 feet MSL (mean sea level). The SP-42DHDxa, SP-50DHDxa and
SP-60DHDxa have been found to operate reliably at altitudes of up to 9000 feet MSL.
At higher elevations, each panel may react differently, depending upon the altitude, air
pressure, humidity and other meteorological factors. If you are planning to use this
product at a location above 9000 feet, please contact Runco technical support for further
information.
Mounting the PlasmaWall
on a Wall or
Table Stand
To install the PlasmaWall, you will need either an optional table stand or wall-mounting kit.
The PlasmaWall cannot be installed on its own.
If you do decide to wall-mount the PlasmaWall, ensure that the wall-mount bracket is
installed according to the instructions included with it. The wall must be capable of
supporting a redundant weight factor three (3) times the weight of the display, or be
reinforced.
Runco recommends that this be done by a custom installation specialist.
You can attach your optional mounts or stand to the PlasmaWall in either of two ways:
• While it is upright.
➤
➤
Use only a Runco-approved wall-mount kit or table stand that is
specifically designed for your display.
Note