Filter
Top Products
PlasmaWall SP Series Owner’s Operating Manual 31
PRE
L
IMINAR
Y
4.1
Turning on the Power
1. Turn on your source components.
2. Plug the female end of the power cord into
the AC receptacle on the rear of the
PlasmaWall. Connect the other end to your
AC power source.
3. Similarly connect the DHD Controller to a
nearby AC outlet.
4. Set the main power switch at the rear of the PlasmaWall (see Figure 2-2) to the “on”
position. Its power indicator lights red.
5. Set the main power switch at the rear of the DHD Controller (see Figure 2-6) to the “on”
position.
6. Press the ON button on the remote control to
turn on the DHD Controller and PlasmaWall (or
press the power button on the front of the DHD
Controller). The power indicator on the DHD
Controller lights solid blue.
7. After a brief warm-up period (approximately 10
seconds), the PlasmaWall will display an image.
4. Operation