Filter
Top Products
Controls and Functions
PlasmaWall SP Series Owner’s Operating Manual 9
PRE
L
IMINAR
Y
1. COMBINATION IN/OUT
Not used.
2. RS-232C (9-pin, male D-Sub)
Connect the RS-232 OUT port on the DHD Controller to this input.
3. AUDIO (OUTPUT) (3.5-mm stereo mini jack)
Not used with this model.
4. AUDIO (INPUT 1) (3.5-mm stereo mini jack)
Not used with this model. Connect the audio outputs from your sources to an external
audio receiver.
5. AUDIO (INPUT 2) (3.5-mm stereo mini jack)
Not used with this model. Connect the audio outputs from your sources to an external
audio receiver.
6. ANALOG RGB OUT (INPUT 1) (15-pin D-Sub)
If desired, connect this output to the RGB input of a second display device.
7. ANALOG RGB IN (INPUT 1) (15-pin D-Sub)
Connect the RGBHV (5xBNC) output from the DHD Controller here.
8. DIGITAL RGB (INPUT 2) (DVI-D)
HDCP-compliant digital video input. Connect the DVI output from the DHD
Controller to this input.
9. EXTERNAL SPEAKER OUTPUT (RIGHT)
Not used. Connect speakers to an external audio amplifier/receiver.
10. EXTERNAL SPEAKER OUTPUT (LEFT)
Not used. Connect speakers to an external audio amplifier/receiver.
11. POWER INPUT (100 to 240 VAC)
Connect the PlasmaWall to power here, using the included power cord.
12. MAIN POWER SWITCH
Connects or disconnects the PlasmaWall from the AC power source.
This output is not active when the PlasmaWall is off or in standby
mode.
Note