Filter
Top Products
PlasmaWall Service Remote Control
PlasmaWall SP Series Owner’s Operating Manual A-3
PRE
L
IMINAR
Y
A.2
Service/Setup Menu
For the vast majority of installations, the DHD Controller remote control gives you all the
control you need over display quality settings. However, there are two settings internal to
the PlasmaWall that can improve the displayed image quality on INPUT 1: VIDEO NR
(noise reduction) and MPEG FILTER. These settings can be found in the Setup Menu,
shown in
Figure A-2.
Figure A-2. PlasmaWall Setup Menu
Video NR (Noise
Reduction)
To apply Digital Noise Reduction (DNR) to the input signal, select Video NR from the
Set-Up menu. Noise reduction is useful for improving the signal-to-noise ratio of video
signals.
To change the Noise Reduction setting on INPUT 1:
1. Press 1 to switch to PlasmaWall INPUT 1.
2. Press MENU on the PlasmaWall Service Remote Control.
3. Press or to select SETUP.
4. Press to select VIDEO NR, then press SET.
5. Press or to select the desired amount of noise reduction (OFF, LOW, MIDDLE or
HIGH).
6. Press SET to confirm your selection.
INPUT 1
PLASMAWALL
SCREEN SET-UP OPTION
PICTURE
COLOR TEMP. : MIDDLE
VIDEO NR
: MIDDLE
AUTO OFF
: OFF
MPEG FILTER
: LOW
CHROMA EE
: ON
FILM MODE : OFF
COLOR SPACE : RGB
SIGNAL : 720p
SETSET
EXIT
MENU