Filter
Top Products
Installation
Runco VX-8d Installation/Operation Manual 39
PRE
L
IMINAR
Y
Connecting to AC PowerProjector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the VX-8d (AC 100V ~ 240V). Then, connect the other end to
your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to a 110
VAC power
source.
3.7
Turning on the Power
1. Turn on your source components.
2. Turn on the main power switch at the rear of the projector.
3. Turn on the main power switch at the rear of the DHD Controller.
4. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input.
5. Press the ON button on the remote control – or the POWER button on the DHD
Controller front panel – to turn on the system. The vacuum fluorescent display on the
DHD Controller front panel briefly displays “Starting Display.”
6. When the projector is ready for use, the fluorescent display indicates the active
source, input resolution/frame rate and aspect ratio; for example:
The input voltage to the AutoScope lens motor must be between
100 and 120 VAC. Do not connect the AutoScope lens motor
to a 200-240
VAC power source!
Caution
VX-8d HDMI 1
16:9 1080i/60
Current
Source
Aspect Ratio
Input Resolution/Frame Rate