Filter
Top Products
6
INSTALLATION
Location
Locate the VM1 Video Matrix with the host system
controller and source equipment to facilitate source
and control connections. Locate the VMR1 Receivers
near the video displays in the zones, within 300 feet
(90 m) of the VM1.
Source Assignments
Because the VM1 tracks the source selections made
by the host system, source numbers must match on
both systems. Thus, a DVD player connected to
source 2 on the multiroom controller also connects
to source 2 on the VM1.
Upconverters in the UC and UC2 models provide con-
nections only for sources 1, 4, 5, and 8. Be sure to
assign your S-video and composite video sources on
the multiroom system accordingly.
Upconverter Configuration
Models with upconverters are factory set to convert
composite video. Follow the procedure below to set
the input switches to S-video or Component as need-
ed before installing the VM1 (see diagram below).
CAUTION
This procedure is for qualified personnel only. To reduce
the risk of electric shock, do not perform this procedure
unless you are qualified to do so.
1. Turn off the power switch.
2. Unplug the power supply from the VM1 chassis.
3. Remove the 9 cover screws on the rear and sides.
4. Pull the cover up off the chassis, lifting one side
first and then the other.
5. Set the switches as shown in the table below.
6. Replace the cover and screws.
Upconverter Switches (0 = Off, 1 = On)
Input 1 or 5 1 2
Component NA 0
Composite 1 1
S-video 0 1
Input 4 or 8 3 4
Component NA 0
Composite 1 1
S-video 0 1
Upconverter input DIP switch settings
Top view of VM1 interior showing upconverter input switch locations
DIP switches