Filter
Top Products
The screen is blank and it is
blinking.
z
If you see the "TEST GOOD" message on the screen when you
pressing the MENU button, check the cable connection between
the LCD Display and the computer to ensure that the connector
is properly connected.
Problems related to Audio
Note
• Problems related to audio signals and their solutions are listed below.
Problems Solutions
No sound.
z
Ensure that the audio cable is firmly connected to both the
audio-in port on your LCD Display and the audio-out port on
your sound card.
(Refer to the Connecting the LCD Display )
z
Check the volume level.
The sound level is too low.
z
Check the volume level.
z
If the volume is still too low after turning the control to its
maximum, check the volume control on the computer sound
card or software program.
The sound is too high or too low.
z
Adjusts the Treble and Bass to the appropriate levels.
Problems related to the Remote Control
Note
• Problems related to the remote control and their solutions are listed.
Problems Solutions
The remote control buttons do not
respond.
z
Check the polarities (+/-) of the batteries.
z
Check if the batteries are empty.
z
Check if the power is on.
z
Check if the power cord is securely connected.
z
Check if a special fluorescent or neon lamp is on in the vicinity.
Q & A
Question Answer
How can I change the frequency?
The frequency can be changed by reconfiguring the video card.
Note that video card support can vary, depending on the version of
the driver used. (Refer to the computer or the video card manual for
details.)
How can I Adjusts the resolution?
z
Windows XP:
Set the resolution in the Control Panel
→
Appearance and
Themes
→
Display
→
Settings.
z
Windows ME/2000:
Set the resolution in the Control Panel → Display → Settings.
* Contact the video card manufacturer for details.
How can I set the Power Saving
function?
z
Windows XP:
Set the resolution in the Control Panel
→
Appearance and
Themes
→
Display
→
Screen Saver.
Set the function in the BIOS-SETUP of the computer. (Refer to
the Windows / Computer Manual).
z
Windows ME/2000:
Set the resolution at the Control Panel
→
Display
→
Screen
Saver.
Set the function in the BIOS-SETUP of the computer. (Refer to