Filter
Top Products
Note
•
The displayed devices differ depending on the external input mode.
• When connecting a PC to the HDMI terminal, set Edit Name to PC. In other cases, set
Edit Name to AV. However, since 640x480, 720p (1280x720), and 1080p (1920x1080)
are common signals for AV and PC, make sure to set the Edit Name in accordance with
the input signal.
• The Picture menu changes depending on the input signal and Edit Name.
When using a DVI to HDMI cable connection (which does not support audio and video at
the same time), the audio port should be connected via a separate audio cable.
• When a PC is connected, set Edit Name to DVI PC to enjoy the video and audio from the
connected PC.
• When an AV device is connected, set Edit Name to DVI Device to enjoy the video and
audio from the connected AV device.
Source AutoSwitch Settings
Turning on the display with
Source AutoSwitch On, and the previous video source selection
is not active, the display will automatically search the different video input sources for active
video.
Note
• Source
AutoSwitch selection and PIP function: If the Source AutoSwitch selection is
set to On, the PIP function will not work, the Source AutoSwitch selection must be set
to Off, for the PIP feature to work.
• When the Source AutoSwitch selection is On, and or the Primary Source Recovery is
On, the display power saving mode becomes inactive.
• When Primary Source Recovery is On, only the Primary Source and Secondary
Source selection are available and they are interchangeable and selectable at will.
Refer to PIP > Source for compatible signals for each primary input source.
Source AutoSwitch
When the Source AutoSwitch is On, the display video source will automatically be searched
for active video.
The Primary Source selection will be activated, if the current video source is not recognized.
Secondary source selection will become active, if no primary video source is available. If
the primary or secondary source is not recognized, the display will search again, if no active
video is found the display will show the no-input-signal message.
Adjusting the LCD Display