Filter
Top Products
5. MagicInfo
UT model can use MagicInfo menu when mounted Network box.
6. TV
This is activated when a TV tuner box is installed.
7. BNC
BNC mode is not supported if the component cable is connected. To use BNC mode,
remove the component cable and connect the BNC cable.
8. Component
Component mode is not supported if the BNC cable is connected. To use Component
mode, remove the BNC cable and connect the Component cable.
Note
• The direct button on the remote control is the 'SOURCE' button.
Edit Name
MENU → ENTER → → → ENTER →
Name the input device connected to the input jacks to make your input source selection
easier.
VCR / DVD / Cable STB / HD STB / Satellite STB / AV Receiver / DVD Receiver / Game /
Camcorder / DVD Combo / DHR / PC
Note
• When connecting a PC to the HDMI or DVI terminal, set Edit Name to PC. In other cases,
set Edit Name to AV. However, since 640x480, 720P (1280x720), and 1080p (1920x1080)
are common signals for AV and PC, make sure to set the Edit Name in accordance with
the input signal.
• The Picture menu changes depending on the input signal and Edit Name.
Adjusting the LCD Display