Filter
Top Products
English _39
USING THE DVR
• Updating the Software
1. Connect a device storing the software to be updated.
(It may take about 10 seconds to recognize the device.)
Upgradeable devices include USB memory and network device.
To update the network, the current DVR should have been
connected to the network.
Upgrade via the proxy server may not be enabled due to the
restricted access.
2. Select <System Management> from <System> window.
3. Select <System Information>.
4. When the recognized device appears, select <Upgrade>.
The <Upgrade> button will be activated only if the current <Software Version> of the <System Information> is
same to or older than that of <S/W Upgrade>.
5. Press <OK> in the “System Upgrade” window.
While updating, it shows the progress.
• Updating progresses with 3 steps as shown in the figure.
6. When the updating is done, it automatically restarts.
Do not turn the power off until it finishes restarting.
M
If “Upgrade Failed” appears, retry from the step 4.
When you experience continued failure, consult the service
center for assistance.
When you perform S/W update remotely using Smart Viewer,
it may take a max of 3 minutes to complete the update since
Smart Viewer popped up a confirmation message. This is to
guarantee that the DVR set operates stably. For a faster
update, use the USB cable to connect to the DVR set.
Software Version
v1.0xh_yymmddhhmmss
Broadcast Format
NTSC
MAC Address 00:00:F0:54:FF:FF
System Management
System Information
Settings
Previous
System Information
Upgrade
Device USB2FlashStorage
Version V1.08_090731170402
S/W Upgrade
System Upgrade
OK Cancel
Current Version v1.0xh_yymmddhhmmss
New Version v1.0xh_yymmddhhmmss
Do you want to upgrade?
Software Version
v1.0xh_yymmddhhmmss
Broadcast Format
NTSC
MAC Address 00:00:F0:54:FF:FF
System Management
System Information
Settings
Previous
System Information
Upgrade
Device USB2FlashStorage
Version V1.08_090731170402
S/W Upgrade
S/W Upgrade
Software upgrading...
Software Version
v1.0xh_yymmddhhmmss
Broadcast Format
NTSC
MAC Address 00:00:F0:54:FF:FF
System Management
System Information
Settings
Previous
System Information
Upgrade
Device USB2FlashStorage
Version V1.08_090731170402
S/W Upgrade
S/W Upgrade
Software upgrading...
S/W Upgrade
Software upgrading...
Do not turn off during the upgrade.