Samsung CFTD2085 DVD VCR Combo User Manual


 
2.5 CHAPTER TWO: INSTALLATION
INSTALLATION
1
Locate the A/V output jacks on the camcorder. They are usually found on the side or rear of the camcorder.
2
Connect an video/audio cable between the VIDEO/AUDIO OUTPUT jack on the camcorder and the
VIDEO/AUDIO terminals on theTV.
If you have mono camcorder, connect L(mono) to camcorder audio out using only one audio cable.
The audio-video cables shown here are usually included with a Camcorder. (If not, check your local electron-
ics store.) If your camcorder is stereo, you need to connect a set of two cables.
Connecting a Camcorder
The front/side panel jacks on your TV make it easy to connect a camcorder to your TV.
They allow you to view the camcorder tapes without using a VCR. (Also see “Viewing a VCR
or Camcorder Tape” on page 3.17)
Note: This figure shows the Standard connector-jack panel. The actual configuration for your
TV may be different.
03233A(E)-CHAPTER 2 11/28/03 1:34 PM Page 5