Filter
Top Products
English - 4
Channel - Memorizing the Channels
Your TV can memorize and store all of the available channels
for both “off-air” (antenna) and cable channels. After the
available channels are memorized, use the
CH and CH
buttons to scan through the channels.
This eliminates the need to change channels by entering the
channel digits. There are three steps for memorizing channels:
“Air/Cable”, “Auto Program” and “Add/Delete”.
Air/Cable
Before your TV can begin
memorizing the available
channels, you must specify
the type of signal source
that is connected to the TV
(i.e., an antenna or a cable
system).
Select “Air” or “Cable” by pressing the ENTER button.
Auto Program
All available channels are
automatically stored in
memory when channels are
selected by the direct tuning
function.
Press the ENTER button
at any time to interrupt the
memorization process.
Add/Delete
You can add or delete
a channel to display the
channels you want only.
To use the “Add/Delete”
function, first run Auto
Program.
Select “Deleted” or “Added”
by pressing the ENTER
button.
Channel - Fine Tune
The Fine Tuning function lets
you manually adjust the TV’s
tuner if you have difficulty tuning
channels.
Adjust the fine tuning by pressing
the ◄ or ► button.
To store the fine tuning setting
in the TV’s memory, press the
MENU button.
To reset the fine tuning to “0”, select ”Reset” by pressing the
▲ or ▼ button, then press the
ENTER button.
Setup - Time
Clock
Setting the clock is
necessary in order to use the
various timer features of the
TV. Also, you can check the
time while watching the TV.
(Just press the INFO button.)
On Timer / Off Timer
You can set the On/Off timers so that the TV will switch on
or off automatically at the time you select.
➢
You must set the clock first.
☛
Auto Power Off
When you set the timer “On”, the TV will eventually turn
off, if no controls are operated for 3 hours after the TV was
turned on by timer. This function is only available in timer
“On” mode and prevents overheating or leakages, which
may occur if a TV is on for too long.
Sleep Timer
You can select a time period of
between 30 and 180 minutes
after which the TV automatically
switches to standby mode.
Press the SLEEP button on the
remote control repeatedly until the
appropriate time interval appears
(any of the preset values from “30
Min.” to “180 Min.”).
Reset
Fine Tune
Move
Save
Adjust Return
P 3 0
Move
Enter Return
Channel
Search
Enter Return
Air 3
3%
Stop
Move
Enter Return
Add/Delete
▲ More
2 : Deleted
3 : Deleted
4 : Deleted
5 : Deleted
6 : Deleted
▼ More
Deleted
Move
Enter Return
Time
Clock -- : -- am
On Timer -- : -- am Off
Off Timer -- : -- am Off
Air/Cable :Air ►
Auto Program ►
Add/Delete ►
Fine Tune ►
30 Min.
AA68-03905G-01_Eng.indd 4 2007-03-14 ｿﾀﾈﾄ 4:01:58