Filter
Top Products
English-56
Setting Up Your Remote Control
Setting Up the Remote to Operate Your Cable Box
1 Turn off your cable box.
2 Press the MODE button and make sure that the CATV appears on
the LCD screen.
3 Press the SET button on your TV’s remote control.
4 Using the number buttons on your remote control, enter three digits
of the cable box code listed on page 58 of this manual for your
brand of cable box. Make sure you enter three digits of the code,
even if the first digit is a “0”.
If there is more than one code listed, try the first one.
5 Press the Power button on the remote control.
Your cable box should turn on if your remote is set up correctly.
If your cable box does not turn on after set up, repeat steps 2, 3, and
4, but try one of the other codes listed for your brand of cable box. If no
other codes are listed, try each code, 000 through 045.
Note on Using Remote Control Modes: Cable Box
When your remote control is in “CATV” mode, the volume
buttons still control your TV’s volume.
01 BN68-00956A-00Eng.qxd 7/19/05 9:02 AM Page 56