Filter
Top Products
English 5
Setting up Your LCD TV/Monitor
Connecting Your LCD TV/Monitor
Figure 2. Cable connections
1. Connecting Computer (
➀
➁
➂
)
A. Connect the power cord to the DC Adaptor and connect the adaptor jack to the DC 14V
power connector on the back of the TV/Monitor.
B. Connect the 15-pin D-SUB of the video signal cable to the PC video connector on the
back of the TV/Monitor.
C. Connect the stereo audio cable to “Audio (ST)” on the back of the TV/Monitor and the
other end to “ Audio Out” terminal of the sound card on your computer.
D. If necessary, please install TV/Monitor driver contained on the accompanied CD. For
driver installation, please refer “Installing Video Driver” section on page 6.
2. Connecting External A/V Devices (
➃
➄
)
A. Connect RCA audio cables to “Audio (R)” and “Audio (L)” terminals and the other ends
to corresponding audio out terminals on the A/V device.
(Stereo-RCA Cable not included)
B. Connect RCA (Yellow) or S-VHS cable to an appropriate external A/V device such as
VCR, DVD or camcorder. (RCA cable and S-VHS cable not included)
C. Headphone may be connected to the headphone output on the right-hand side of the
TV/Monitor (
➅
).
While the headphone is connected, the sound from the built-
in speakers will be disabled.
3. Connecting scart and TV/CATV (
➆
➇
)
A. Connect Scart Cable such as TV etc... (Scart cable not included)
B. Connect an antenna or CATV cable to the antenna terminal on the back of the
TV/Monitor.
V
I
D
E
O
S
-
V
I
D
E
O
DC
POWER
VIDEO AUDIO(ST)
SCART
TV or VCR
4E_body3p.fm Page 5 Wednesday, December 19, 2001 4:09 PM