Filter
Top Products
English - 32
Troubleshooting for Anynet ¦
+
Problem Possible Solution
Anynet
+
does not work. Check if the device is an Anynet
●
+
device. The Anynet
+
system
supports Anynet
+
devices only.
Connect only one receiver (home theater).
●
Check if the Anynet
●
+
device power cord is properly connected.
Check the Anynet
●
+
device’s Video/Audio/HDMI 1.3 cable
connections.
Check whether Anynet
●
+
(HDMI-CEC) is set to On in the
Anynet
+
setup menu.
Check whether the TV remote control is in TV mode.
●
Check whether it is Anynet
●
+
exclusive remote control.
Anynet
●
+
doesn’t work in certain situations. (Searching
channels, Operating, Plug & Play, etc.)
When connecting or removing the HDMI 1.3 cable, please
●
make sure to search devices again or turn your TV off and on
again.
Check if the Anynet
●
+
Function of Anynet
+
device is set on.
I want to start Anynet
+
. Check if the Anynet
●
+
device is properly connected to the
TV and check if the Anynet
+
(HDMI-CEC) is set to On in the
Anynet
+
Setup menu.
Press the TV button on the TV remote control to switch to TV.
●
Then press the TOOLS button to show the Anynet
+
menu and
select a menu you want.
I want to exit Anynet
+
. Select View TV in the Anynet
●
+
menu.
Press the SOURCE button on the TV remote control and select
●
a device other than Anynet
+
devices.
Press
●
z
, CH LIST, PRE-CH, and FAV.CH to change
the TV mode. (Note that the channel button operates only when
a tuner-embedded Anynet
+
device is not connected.)
The message Connecting
to Anynet
+
device...
appears on the screen.
You cannot use the remote control when you are conguring
●
Anynet
+
or switching to a view mode.
Use the remote control when the Anynet
●
+
setting or switching
to view mode is complete.
The Anynet
+
device does
not play.
You cannot use the play function when Plug & Play is in
●
progress.
The connected device is
not displayed.
Check whether or not the device supports Anynet
●
+
functions.
Check whether or not the HDMI 1.3 cable is properly
●
connected.
Check whether Anynet
●
+
(HDMI-CEC) is set to On in the
Anynet
+
setup menu.
Search Anynet
●
+
devices again.
You can connect an Anynet
●
+
device using the HDMI 1.3 cable
only. Some Some HDMI cables may not support Anynet+
functions.
If it is terminated by an abnormal situation such as
●
disconnecting the HDMI cable or power cord or a power failure,
please repeat the device scan.
The TV program cannot
be recorded.
Check whether the antenna jack on the recording device is
●
properly connected.
The TV sound is not
output through the
receiver.
Connect the optical cable between TV and the receiver.
●