Filter
Top Products
The values of Fine, Coarse, Position are adjusted automatically. By changing the resolution
in the control panel, the auto function is performed.
(Available in PC mode only)
Note
The direct button on the remote control is the 'AUTO' button.
Signal Balance
This is used to make up for the weak RGB signal transmitted by a long signal cable.
MENU → → ENTER → [Picture] → → → → → → → ENTER → [Signal Bal-
ance]
(Available in PC mode only)
Signal Balance
MENU → → ENTER → [Picture] → → → → → → → ENTER → [Signal Bal-
ance] → ENTER → [Signal Balance] → , → ENTER
Selects either On or Off with the signal control.
Signal Control
MENU → → ENTER → [Picture] → → → → → → → ENTER → [Signal Bal-
ance] → → ENTER → [Signal Control]
1. R-Gain
MENU →
→ ENTER → [Picture] → → → → → → → ENTER → [Signal
Balance] → → ENTER → [Signal Control] → ENTER → [R-Gain] → , → ENTER
2. G-Gain
MENU →
→ ENTER → [Picture] → → → → → → → ENTER → [Signal
Balance] → → ENTER → [Signal Control] → → ENTER → [G-Gain] → , →
ENTER
3. B-Gain
Adjusting the PDP Display