Filter
Top Products
CHAPTER THREE: TV OPERATION 3.5
OPERATION
4
While “Red” is highlighted, press the
joystick to enter: A crosshair pat-
tern will appear on the screen.
Move the joystick up/down/left/right
to select where to adjust
Convergence.
5
If a horizontal red line is visible, use
CH and CH buttons to move
the line so that it is superimposed on
the horizontal center-line (i.e., make
a single horizontal line that is as
white as possible.)
6
If a vertical red line is visible, use
the VOL + and VOL - buttons to
move the line so that it is superim-
posed on the vertical-center line
(i.e., make a single vertical line that
is as white as possible.)
Adjust Red Convergence
7
For ‘Blue’ adjustment, do the same as the above.
After the red convergence is correctly adjusted, press Menu to exit
all the menus.
Note: Since the center convergence adjustments can’t be done after
completing the side convergence adjustments, do the center conver-
gence adjustments first. If you have done the side convergence
adjustments first, then end the Convergence Adjustments by press-
ing the Menu button, Then re-start from No. 3 on page 3.4 to adjust
the center convergence.