Filter
Top Products
4.
4.
Use the UP/DOWN or LEFT/RIGHT button to
select the desired item. Then press the ENTER
button.
5.
5.
Use the UP/DOWN button to select speaker
mode desired. Then press the ENTER button.
Setting up SPEAKER MODE
• If you have connected the system to a speaker with low fre-
quencies of 100Hz or below, select ‘Found(Large illustration)’.
• If you have connected the system to a speaker without low
frequencies of 100Hz or below, select ‘Found(Small illustra-
tion)’. If you don’t connect a subwoofer, always select
‘Found(Large illustration)’ for the Front Speakers(L/R).
• When you don’t have a particular speaker connected, select
‘Not found(No illustration visible)’.
Setting up DELAY TIME
• When 5.1CH Surround Sound is played, you can enjoy the
best sound if the distance between you and each speaker is
the same. You can set Delay Time in the Center/Surround
Speaker to customize the sound to the acoustic of your room.
• Setting CENTER
SPEAKER
If the distance of Dc is
equal to or longer than the
distance of Df in the left
figure, set the mode as
Oms. Otherwise, change
the setting according to
the table below.
(A) = Df - Dc
Distance of (A)(in) Setting(ms)
1.64 1.3
3.28 2.6
4.92 3.9
6.56 5.3
• Setting SURROUND SPEAKERS
If the distance of Df is equal to the distance of Ds in the
above, set the mode as Oms. Otherwise, change the setting
according to the table on the right. (B) = Df - Ds
Distance of (B)(in) Setting(ms)
6.56 5.3
13.12 10.6
19.68 15.9
Setting up TEST
The test output signals come clockwise starting from the Front
Speaker(L). Adjust Channel Balance to match to the volume of
test signals memorized in the system.
FRONT(L) CENTER FRONT(R)
SUBWOOFER SURROUND(R) SURROUND(L)
Surround Sound Speaker Setup (DVD-909 only)
DD
DD
VV
VV
DD
DD
36
1.
1.
Press the SETUP button in play or stop mode.
2.
2.
Press the UP/DOWN button to select AUDIO
OPTIONS. Then press the ENTER button.
3.
3.
Use the UP/DOWN button to select SPEAKER
SETUP. Then press the ENTER button.
SPEAKER MODE
You can set a mode in the system that’s currently used.
Initially it is set as follows:
• Front speaker (L/R) : Found (Large illustration)
• Center speaker : Not found (No illustration visible)
• Subwoofer : Not found (No illustration visible)
• Surround speaker (L/R) : Not found (No illustration visible)
DELAY TIME
You can customize the sound to conform to the acoustics of
your room by adding a delay effect to the sound of the Center
and Surround Speakers. Initially it is set as “Oms (millise-
conds)”.
TEST
Test signals memorized in the system are sent to each
speaker.
CHANNEL BALANCE
Adjust the output level of a speaker by using test signals that
are memorized in the system. Initially it is set as “OdB”.
Speaker Mode
(Front L)
Speaker Mode
(Center)
Speaker Mode
(Front R)
Speaker Mode
(Subwoofer)
Speaker Mode
(Surround R)
Delay Time
(Surround L/R)
Oms
Speaker Mode
(Surround L)
TEST
Channel
Balance
(Center)
OdB
Channel
Balance
(Subwoofer)
OdB
Channel
Balance
(Surround L)
OdB
Delay Time
(Center)
Oms
Channel
Balance
(Surround R)
OdB
• Arrange all
speakers
within circle.
Ideal CENTER SPEAKER position
Ideal SURROUND SPEAKER position
SPEAKER SETUP
How to make the SETUP MENU disappear or
return to menu screen during set up.
Press RETURN button.
The DVD-909 has a Speaker Setup feature that allows you to customize your surround sound setup.
N
O
T
E
• The subwoofer test output signal is lower than the other
speakers.
• The MPEG Multichannel logo is a trademark registered by
PHILIPS Corporation.