Filter
Top Products
15
Switching On and Off
ENG
If your Media Station isn’t turned on when the power button is
pressed, please check if the “TV” mode has been chosen by
pressing the “Select” button.
1 Plug the mains lead of the PDP and Media Station into an appropriate socket.
2 Connect the video cable between the DISPLAY SIGNAL IN on the rear of the PDP and the DISPLAY
SIGNAL OUT
on the rear of the Media Station.
3 Press the POWER button on the front panel of the Media Station or remote control to switch the display on.
Rear of the Media Station
-
Video Cable
Rear of the PDP
-
Power cord
-
Power cord
☛
◆ Do not connect the power cord
between PDP and Media Station.
Otherwise, the
EMI characteristic will
become worse because power input
and output signals interrupt each other.
◆ The ferrite core is used to attenuate
undesired signals. When you connect
the power cord to the
POWER IN
connector on the rear of the Media
Station, bind the power cord round the
ferrite core to secure it.