Filter
Top Products
5.12 C
HAPTER FIVE: VCR OPERATION
VCR OPERATION
▼
12
Press the MENU button to
exit the menu system and
return to normal viewing.
To enter additional program
recording times, repeat steps 1-11.
If you enter two program times that
overlap, a program overlap warning
appears on the TV screen, along with
instructions for fixing the overlap.
The timer indicator on the front panel
of the TV illuminates when program
times have been stored.
The TV should be turned off to
record the programs you’ve chosen.
13
Press the POWER button
to turn off the VCR.
IMPORTANT:
• The TV should be off to record the programs you’ve chosen. But, if you are recording
a channel that comes through a cable box, be sure to leave the cable box turned on
and tuned to the channel you want to record.
• When a timer recording is in progress, there is no picture on the monitor because the
power is off. If you want to watch the channel while it's being recorded, press POWER
on the remote control only.
• One-time timer programs clear from memory automatically when the recording is
finished. Daily and weekly programs remain in the timer until you remove them.
If power to the TV is interrupted,timer program will be removed from memory.
The clock and calendar, however, must be reset.
11
Press the UP/DOWN▲▼
button to select “Mode”,
then press the
UP/DOWN▲▼ buttons to
select “Once”, “Wkly”, or
“Daly”.
▼
For more information on
selecting tape speeds, see pages 5.6,
5.7, and A.2.
10
Press the UP/DOWN▲▼
button to select “SPEED”,
then press the
LEFT/RIGHT
œœ√√
buttons
to select speed at which
you want to record.