Filter
Top Products
English - 75
Changing the Channel of the Sub (PIP) Picture
After you set the signal source (antenna or cable) of the sub picture, it is easy to change channels.
1
Press the MENU button.
Press the
œ or √ button to select
“PIP”, then press the ENTER button.
2
Press the … or † button to select
“Channel”, then press the ENTER
button.
3
Press the … or † button to select a
channel you want, then press the
ENTER button.
Select “Return” by pressing the
… or † button, then press the ENTER
button to return to the previous menu.
Press the EXIT button to exit.
Alternate method
Press the CH or CH button at the button of the remote control
to change the sub picture channels while PIP is on.
• Air : “Air” antenna signal
Cable : “Cable” antenna signal
PIP
Enter
PIP
PIP
Swap
Size
Position
Air/Cable
Channel
On
Cable
Cable 3
Return
Cable 3
PIP
Enter
PIP
PIP
Swap
Size
Position
Air/Cable
Channel
On
Cable
Cable 3
Return
Cable 11
PIP
Enter
PIP
PIP
Swap
Size
Position
Air/Cable
Channel
On
Cable
Cable 3
Return
▲
▼
▲
▼
•You can set a channel by pressing the number buttons on the
remote control. This can be performed in the PIP-channel menu.
BP68-00588H-00Eng(060~079) 4/25/06 3:36 PM Page 75