Filter
Top Products
3.5 CHAPTER THREE: TV OPERATION
OPERATION
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna)
and cable channels. After the available channels are memorized, use the CH ▲ and
CH ▼ buttons to scan through the channels. This eliminates the need to change channels
by entering the channel digits. There are three steps for memorizing channels: selecting a
broadcast source, memorizing the channels (automatic) and adding and deleting channels
(manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press the MENU button to
display the menu.
Press the CH ▼ button to
select “Channel”, then
press the VOL + button.
Channel
Move Select
Menu
ANT/CATV Ant
Auto Program
Fine Tune 00
LNA : Off
TV/Video TV
2
Repeatedly press the
VOL + button to cycle
through these choices:
ANT (antenna), STD, HRC
or IRC (all cable TV).
Channel
Move Select
Menu
ANT/CATV STD
Auto Program
Fine Tune 00
LNA : Off
TV/Video TV
Note: STD, HRC and IRC identify various types of cable TV
systems. Contact your local cable company to identify the type
of cable system that exists in your particular area.
At this point the signal source has been selected. Proceed to
“Storing Channels in Memory” (next page).