Filter
Top Products
2.3
INSTALLATION
Connecting to a Cable Box that Descrambles All Channels
1
Find the cable that is
connected to the
ANTENNA OUT
terminal on your
cable box.
This terminal might be labeled
“ANT OUT,” “VHF OUT,”
or simply, “OUT.”.
2
Connect the other end
of this cable to the
TVANTENNA terminal
on the back of the TV.
Connecting to a Cable Box that Descrambles Some Channels
If your cable box descrambles only some channels (such as premium channels), follow the
instructions below. You will need a two-way splitter, an RF (A/B) switch, and four lengths of
coaxial cable. (These items are available at most electronics stores.)
1
Find and disconnect the
cable that is connected
to the ANTENNA IN
terminal on your
cable box.
This terminal might be labeled
“ANT IN,” “VHF IN,”
or simply, “IN.”.
2
Connect this cable
to a two-way splitter.
3
Connect a coaxial cable
between an OUTPUT
terminal on the splitter
and the IN terminal on
the cable box.
06-CHAPTER 2_en 6/9/03 10:55 AM Page 3