Filter
Top Products
14
ENG
When the television is initially powered on, several basic customer
settings proceed automatically and subsequently. The following
settings are available.
1 If the television is in Standby mode, press the Power ( ) button
on the remote control.
Result
: The message Plug & Play is displayed. It flickers for
a little while and then
Language menu is automatically
displayed.
2 Select the appropriate language by pressing the ▼ or ▲ button.
Press the
Menu button to enter the language.
Result
: The message Antenna input check is displayed.
➣
If any language is not selected on the Language menu, the
Language menu will disappear about 30 seconds later.
3 Make sure that the antenna is connected to the TV.
Press the
➛ or ❿☎button.
Result
: The ATM menu is displayed.
4 Select your country by pressing the ➛ or ❿ button.
5 To search the channels, press the button.
Result
: The channels are stored in an order which reflects
their positions in the frequency range. Finally, the
search will end automatically. When the channels
have been stored, the
Time menu is displayed with
Clock is selected.
➢ To stop the search before it has finished, press the Menu
button.
6 Press the ➛ or ❿☎button to move to the hour or minute.
Set the hour or minute by pressing the
▼ or ▲ button.
➣
Refer to “Setting and Displaying the Current Time” on page
34.
7 When you have finished, press the Menu button.
Result
: The message Enjoy viewing your new TV is
displayed, and then the channel which has been
stored will be activated.
Plug and Play Feature
English
ЬА
Hrvatski
Čeština
Netherland
Français