Samsung SRD-830DC DVR User Manual


 
English _67
USING THE DVR
Focus : Enables you to adjust the focus manually.
Auto Pan : The camera automatically runs between the two points that you selected.
This is not available for the coaxial type of communication.
Scan : The camera moves to the preset points in the specified sequence.
If multiple presets are specified, the PTZ camera will automatically move to all of the preset points one at a time.
Pattern : Makes the PTZ camera remember and follow the past route.
For RS-485 communications, functions of Auto Pan, Scan and Pattern are supported by Samsung, Panasonic and Pelco
protocols. However, the menu name and operation may differ depending on the protocol. (Panasonic: Auto Pan, Sequence,
Sort / Pelco: Auto Pan, Frame Scan (or Scan), Pattern)
For the coaxial communications, the operation may differ depending on the protocol.
Before entering the PTZ device control mode, set the values of the PTZ device in the <Setting the PTZ> menu.
(Page 45)
For camera specifications that supports PTZ comtrol depending on communication method, refer to our web site.
Preset Setting
A preset is a set of specific target points of a PTZ camera, and up to 20 presets per a camera can be stored.
Using the mouse may help make setup easier.
In PTZ Control mode, use the direction buttons to adjust the camera in a desired direction.
Select the <Save> key.
The virtual keyboard for inputting the preset will appear.
Refer to “Using Virtual Keyboard”. (Page 36)
Save : You can add and save the preset.
Rename : You can change the settings of the existing presets.
Delete : Deletes the selected preset.
Delete All : Deletes all existing presets.
If you replace the camera of the channel that stores the preset list with a new one, you should reset the preset
accordingly.
Press <OK>.
The preset will be saved as a name that you entered.
Camera Setting
A PTZ camera has its own menu system. Optimize the PTZ camera according to the DVR.
Using the mouse may help make setup easier.
Connect the PTZ camera to the DVR and run the PTZ
camera again to display the camera’s protocol setting
window.
Check the protocol ID of the camera.
In “Device > Setting the PTZ”, enter the PTZ camera ID in the
ID input box of the channel that is connected to the PTZ camera.
(Page 45)
Select <Camera Setup> in the PTZ Control menu.
The camera-specific menu appears.
You can configure the settings of only those cameras that support
the protocols of Samsung, Pelco D/P, AD and Panasonic.
If you are setting Auto Pan or Pattern in the camera menu, press
and hold the appropriate button for a certain time so that the button
operation can be different from that in normal PTZ setting.
M
1.
2.
M
3.
1.
2.
3.
SAMSUNG PROTOCOL
ADDR 0
TYPE RS-485,HALF
BAUD 9600
LENS OK!
TILT OK!
PAN OK!
**
MAIN MENU
**
CAMERA SET...
VIDEO SET...
PRESET...
ZONE SET...
AUTO SET...
ALARM SET...
OTHER SET...
CLOCK SET...
SYSTEM INFO...
Camera Setup
Exit