Samsung SVR-950 DVR User Manual


 
SVR-1650/1640/950 User Manual
79
5
5.9 Communication setup
Setup items needed to connect a computer to a network. Communication setup screen is as shown below. If
‘ENTER’ key, located in the front of DVR, is pressed or if lower level menu is selected with the mouse,
detailed items may be viewed.
5.9.1 NETWORK
9 IP ADDRESS : Input the [IP address ]
obtained from the internet service company
of the user.
9 DHCP [ON/OFF] : Select whether to get the
IP address automaticcally using the Dynamic
Host Configuration Protocol.
9 TYPE [Ethernet/xDSL] : Select the network
type connected to the DVR.
You are recommended to reboot your DVR when changing the type of
communication line.
Especially, when switching to Ethernet from xDSL or DHCP, first switch the line
type to Ethernet and the save the changes.
Then, reboot your DVR. When rebooting is completed, make sure to check
whether the line has been successfully switched to an Ethernet-type.
After that, enter the IP Address that you want to use.