Filter
Top Products
INSTALLATION
English - 15
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna
or a cable TV system (according to the instructions on pages 11~14).
1
Connect a coaxial cable between the
“ANT IN ” terminal on the TV and the
antenna out terminal on the VCR.
A coaxial cable is usually included with
a VCR. (If not, check your local
electronics store).
2
Connect a set of audio cables between
the “AV IN 1 (L, R)” (or “AV IN 2/3 (L,
R)”) jacks on the TV and AUDIO OUT
jacks on the VCR.
If you have a mono VCR, connect
L(mono) to VCR audio out using only
one audio cable.
3
Connect a video cable between the “AV
IN 1 (VIDEO)” (or “AV IN 2/3 (VIDEO)”)
jack on the TV and the VIDEO OUT jack
on the VCR.
Refer to your VCR’s instructions for
more information about how to view
your VCR tape.
TV Rear Panel
•Also, you can connect to “AV IN 1” on the side panel of TV.
AA68-03644A-00Eng 6/23/05 2:33 PM Page 15