Filter
Top Products
English - 10
Memorizing the Channels
Your TV can memorize and store all of the available channels for both air and cable
channels. After the available channels are memorized, use the CH and CH button
to scan through the channels. This eliminates the need to change channels by entering
the channel digits. There are three steps for memorizing channels: selecting a broadcast
source, memorizing the channels(automatic) and adding or deleting channels(manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV(i.e. an air or a cable system).
1 Press the MENU button to display the menu.
Press the ▲ or ▼ button to select Channel, then press the ENTER button.
2 Press the ENTER button select Antenna.
Press the ▲ or ▼ button to select Air or Cable, then press the ENTER button.
Storing Channels in Memory (Automatic Method)
3 Press the ▲ or ▼ button to select Auto Program, then press the ENTER button.
4 Press the ▲ or ▼ button to select the antenna connection, then press the ENTER button.
5 Press the ENTER button to start.
First analog, then digital channels will be memorized.
When selecting Cable TV:
7 Press the ▲ or ▼ button to select Cable, then press the ENTER button.
The Cable System menu is displayed.
8 Press the ▲/▼/◄/► buttons to select the cable system for analog and digital channels
respectively, then press the ENTER button.
➢
STD, HRC, and IRC identify various types of cable TV systems. Contact your local cable
company to identify the type of cable system that exists in your particular area.
At this point the signal source has been selected.
9 Press the ENTER button to start.
The TV begins memorizing all available channels.
Press the ENTER button to stop.
➢
When you select Cable or Air+Cable it also executes “Clearing Scrambled Channels”
simultaneously. See page 15.
➢
This TV can receive Digital HD (High Definition) signals, but converts them to SD (Standard
Definition) for viewing.
You can also press the AUTO PROG. button on the remote control to bring up the Auto
Program menu.
Move
Enter
Return
Antenna :
Auto Program
Clear Scrambled Channel
Add/Delete
Fine Tune
Name
Signal Strength
Channel
Air
Cable
Move
Enter
Return
Channel
Antenna : Air ►
Auto Program ►
Clear Scrambled Channel ►
Add/Delete ►
Fine Tune ►
Name ►
Signal Strength ►
Auto Program
Move
Enter
Return
Air
Cable
Air+Cable
Auto Program
Move
Enter
Return
Start
STD
Cable System
Analog
HRC IRC
STD
Digital
HRC IRC
Auto Program
Enter
Return
Stop
Auto Program in progress
STD 120 3%
Scrambled Channels Searched
AA68-03783D-01Eng.indd 10 2007-02-09 ｿﾀﾀ・10:22:48