Filter
Top Products
3
Read these Instructions.
• Keep these Instructions.
• Heed all Warnings.
• Follow all instructions.
• Clean only with a damp cloth (unplug the power adapter before cleaning).
• Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
• Do not defeat the safety purpose of the polarized or grounding - type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the third prong is provided for
your safety. When the provided plug does not fit into your outlet, consult an electrician
for replacement of the obsolete outlet.
• Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
• Only use attachments/accessories specified by the manufacturer.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
• Do not use near water (e.g. sink, bathtub, swimming pool, etc.).
Warning:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLTAGES ARE
PRESENT INSIDE THE ENCLOSURE. DO NOT OPEN THE CABINET. REFER
SERVICING TO QUALIFIED PERSONNEL ONLY.
Note:
Please consult the rating label at the bottom of the SanDisk V-Mate for power input and
other safety information.
Connecting V-Mate
1. Connect one audio/video cable to the composite video output and audio left/right output
of an analog video source (e.g. cable/satellite box, camcorder, VCR or DVD player).
The yellow plug should connect to Video Out, the red plug should connect to Audio Out
(R), and the white plug should connect to Audio Out (L). Connect the 3.5 mm connector
on the other side of the cable to the AV In connection on the back of the V-Mate.
2. If you are using a cable/satellite/terrestrial receiver box or VCR, connect the 3.5 mm
connector on the IR Emitter cable to the IR Emitter connector on the back of the
V-Mate. The IR emitter will automatically power on/off and select channels at cable/
satellite/terrestrial receiver box or VCR during a scheduled recording. Remove the
protective layer from IR emitter and stick the IR emitter next to the remote sensor of
the cable/satellite/terrestrial receiver box or VCR. When attaching the IR emitter to the
video source box, make sure to cover only a part of the IR Receiver window so that it
will not block the IR signal coming from the remote control. To find the remote sensor
on the video source box, consult its manual for more information.
OFF/ON 5v DC
INOUT
AV
PAL/NTSC IR Emitter
Video Source
Box (front)
IR Emitter
IR Receiver
3. Connect the 2nd audio/video cable to the TV. On the TV, the yellow plug should
connect to Video In, the red plug should connect to Audio In (R), and the white plug
should connect to Audio In (L). Connect the 3.5 mm connector on the other side of the
cable to the AV Out connection on the back of the V-Mate.
4. Plug the Power Supply into the back of the V-Mate and plug the power supply into a
power outlet.