Sanus Systems LF228 TV Mount User Manual


 
6901-002114 <01>
13
6 Cable Management
002552.eps
LF228 - run cables
002552.eps
LF228 - run cables
002552.eps
LF228 - run cables
1
2
3
4
[29]
[29]
[03]
[03]
[01]
(C)
3. Pull each arm to its full extension then route the cables
through the arm, leaving enough slack to prevent
stretching the cables when the arm is moved.
4. Reattach covers (C).
1. Fully extend the arm [03]. Remove cable covers (C).
2. Install the cable tie clips [29] and ties [30] into the bottom
of the arm, as shown.
(C)
Troubleshooting and Maintenance
To remove the TV: (See illustrations in step 4.)
1. Unscrew the locking screw [22].
2. Push to release the locking tab (L).
3. Carefully lift the TV from the arm [03].
TV will not hold the downward tilt position and floats upward:
1. Adjust tilt tension setting (see step 5-3).
2. If the problem persists, use a bracket installation option that uses longer spacers (see step 1-4).
TV will not hold the home position and floats downward:
1. Adjust tilt tension setting (see step 5-3).
2. If the problem persists, use a bracket installation option that uses shorter spacers (see step 1-4).
[30]