Filter
Top Products
English - 21 -
Initial Settings
When the TV set is operated for the fi rst time,
the IDTV turns on fi rst.
Because this is the fi rst time the TV is used,
there are no channels stored in the memory.
When the TV is turned on for the fi rst time, the
menu for the language selection appears on the
screen. The message “Welcome please select
your language!” is displayed in all language
options sequentially in the OSD.
By pressing the “
” or “ ” buttons highlight the
language you want to set and press OK button.
After then, “First time installation” OSD will
appear on the screen. By pressing “ ” or “ ”
buttons, select the country you want to set and
press OK button. button (** for EU countries).
Note: Country selection OSD will not be
available for UK.
After then, the active antenna selection OSD
appears on the screen:
By pressing “left cursor ikonu ” or “right cursor
ikonu” buttons, set active antenna mode as on
or off.
If an active antenna is connected to your TV,
you can select this option as On. Antenna
power should be “Off” when standard antenna
is used instead of the active antenna. See
Confi guration Menu in the following sections
for more information.
Press OK button on the remote control to
continue and the following message will be
displayed on the screen:
To start installation process, select “Yes”, to
cancel select “No”.
• To select the “Yes” or “No” option, highlight the
item by using “
” or “ ” buttons and press the
OK button.
The IDTV will automatically tune to the UHF or
VHF (** for EU countries) transmission channels,
searching for digital terrestrial TV broadcasts
and displaying the names of channels found.
This process will take about a few minutes. To
cancel searching, you can press the “M” button
at any time during the process.
After Automatic Search is completed, the
following message asking for analogue channel
search appears on the screen:
To search for analogue channels, select “Yes”.
TV switches to the analogue TV mode. The
menu below is displayed to search for analogue
channels:
Select your Country, Language and Text
language by using “
” or “ ” and “ ” or “ ”
buttons. Press OK or RED button to continue.
To cancel, press the BLUE button.
For more information on this process, see
“Install Menu” section.
Note : For proper functioning of digital teletext in DTV
mode, you should set country as UK in analogue
AUTO PROGRAM (for UK only).
MB35_[GB]_SSM_32908W_3920UK_UKIDTV_BRONZE3_POWER-SAVE-MODE-10068800_50168019.indd 21MB35_[GB]_SSM_32908W_3920UK_UKIDTV_BRONZE3_POWER-SAVE-MODE-10068800_50168019.indd 21 01.07.2010 14:59:0201.07.2010 14:59:02