Sanyo DP50749 Flat Panel Television User Manual


 
19
Need help? www.sanyoctv.com 1-800-877-5032
CHECKING THE CODES
If you have set up the remote using the procedure
in “Searching for Your Code”, you may need to
find out which five-digit code is operating your
equipment. For example, to find out which code is
assigned to your DVD:
1. Press DVD once.
2. Press and hold SET until the red LED blinks
twice, then release.
3. Enter 9 9 0. The LED blinks twice.
4. To view the first digit of the code, press 1.
Count the red LED blinks (for example, three
blinks = 3), and write down the number.
NOTE: If a code digit is 0, the LED does not blink.
5. Repeat step 4 for the four remaining digits,
using 2 for the second digit, 3 for the third digit,
4 for the fourth digit, and 5 for the fifth digit.
6. To check for other device codes, repeat steps
1—5, substituting the device key for the desired
mode you would like to check.
USING LEARNING
This universal remote control includes a Learning
feature (some models may not include Learning)
so you can add functions that are unique to your
home entertainment devices (e.g., VCR Tracking
Up or Down.) However, there are considerations.
LEARNING FEATURE PRECAUTIONS
Your original remote controls must be in work-
ing order for learning to work properly.
Learned keys are mode-specific, so each one
can store a unique function for each mode.
Do not use the following keys for Learning:
DEVICE KEYS, SET, or RECORD (
)
Learning capacity is approximately 42 to 75
keys, depending on the code being learned
Certain device functions are not learnable
including multi-frequency types, some high fre-
quency functions, and other unusual formats.
For optimum learning, avoid high levels of
ambient light such as natural sunlight or
energy-efficient fluorescent lights.
NOTE: Please have your original remote controls
handy before programming Learning.
PROGRAMMING A LEARNED KEY
NOTE: If more than 10 seconds pass between key
presses, the remote exits programming.
1. Place the GXDB and your original control head-
to-head (about 2” apart). Also locate the key
(on your original remote control) that you want
the GXDB to learn. Press the mode key you
wish to learn functions on.
2. Press and hold SET until the LED blinks twice,
then release.
3. Enter 9 7 5. The LED blinks twice.
NOTE: If the LED displays one long flash instead, either
your batteries are low, or the remote has a memory
fault. In either case, the remote cannot learn a new key.
4. On your GXDB remote, press the key that you
wish to learn onto. The feedback LED stays lit
for three seconds, suggesting the remote is
ready to learn.
5. On the original remote, press and hold the key
to be learned. Continue holding the key on the
original remote until the GXDB’s LED blinks
twice.
NOTE: If the red LED displays one long blink, a learning
error has occurred. Try repeating this step again until a
successful capture occurs. If the function is still not cap-
tured, press and hold SET to exit programming and
review the “Learning Feature Precautions”.
6. Repeat steps 4 through 5 for another key you
would like to learn onto. Once you have com-
pleted learning all keys, press and hold SET
until the LED blinks twice to save all data
learned.
UNIVERSAL REMOTE CONTROL, ADVANCED OPERATION
(Advanced operations continued on page 20.)