Filter
Top Products
CONNECTING A SATELLITE SYSTEM, VCR, AND ANTENNA TO THE TV FOR PIP OPERATION
Cables are not supplied.
❶ Connect an antenna signal to the TV 75Ω (ohm) terminal.
❷ Connect Satellite S-Video Out to TV S-Video In jack. Using the S-Video In jack overrides the Video Input jack.
Connect the Satellite Audio Out (R/L) jacks to TV Audio Input (R/L) Jack (AV1) jacks.
❸ Connect the VCR Audio/Video out jacks to the TV Audio/Video AV2 In jacks.
❹ Connect RF cable from the Satellite Receiver “Out to TV” to the VCR “In from ant.”
❺ Press the POWER key to turn on the TV. Turn on external equipment.
TO USE PIP:
1. Press the PIP ON/OFF key.
2. Press the SELECT key to activate (highlight) the PIP window.
3. Press the INPUT key to select the input signal source for the PIP window (AV1 [Satellite], AV2 [VCR], or antenna).
4. Refer to page 16 to operate PIP, if needed.
Notes: – PIP feature will not function with just the satellite system, you must connect another signal source such
as a cable system or antenna to the TV 75 ohms jack or AV jacks.
– This connection allows you to use your VCR to record a signal from the Satellite Receiver.
IN FROM
SAT.
CATV IN
OUT TO TV
S-VIDEO
CH3
CH4
A/V JACKS
OUT
-RL-AUDIOVIDEO
UHF/VHF/CATV
75Ω
S-VIDEO
VIDEO AUDIO INPUT
Y
P
b
Pr
AV2
COMPONENT
RRR R
L L L L
(MONO)
(MONO)
AUDIO
OUTPUT
VIDEO
AUDIO
AV1
FROM ANT.
OUT TO TV
-RL-AUDIOVIDEO
A/V JACKS
CH3 CH4
RF
CHANNEL
IN
OUT
IN
OUT
-RL-AUDIOVIDEO
❷
❶
Satellite Receiver
Back
TV Back
Antenna
PIP Satellite Hookup
❷
❸
VCR Back
❹
17
What you will need for connections:
❷
Audio Cable – 1
❷
S-Video Cable – 1
❸
AV Cable – 1
❹
RF Cable – 1