Filter
Top Products
CATV FRANCHISE NOTE:
Cable companies, like public
utilities, are franchised by
local government authorities.
To receive cable programs,
even with equipment which is
capable of receiving cable
channels, the consumer
must subscribe to the cable
company’s service.
QuickTips
■
The TV will automati-
cally select the
correct Antenna
mode for the type of
RF signal you
connect.
■
TV will switch off
automatically after 15
minutes if there is no
signal reception
(cable out or station
not broadcasting).
Exception—When the
Video mode is
selected, the TV will
not automatically
switch off when
signal reception has
stopped for 15
minutes.
■
If you move the TV to
a new location, press
the RESET key twice
after connecting the
signal and turning on
the TV.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
IN FROM
SAT.
CATV IN
OUT TO TV S-VIDEO
CH3
CH4
L- -RAUDIOVIDEO
L- -RAUDIOVIDEO
IN
OUT
UHF/VHF/CATV
75Ω
VIDEO AUDIO INPUT
COMPONENT
AV2
AV1
S-VIDEO
VIDEO
(MONO)
AUDIO
R
L
RR
LL
Y
P
b
Pr
AUDIO
OUTPUT
FROM ANT.
OUT TO TV
IN
OUT
CONNECTING CABLE SERVICE, RF ANTENNA, OR SATELLITE DISH
RECEIVER TO TV
❶
❶
❶
Cable Box
RF Antenna
Satellite Receiver
TV Back
INITIAL SET-UP
1.
Install batteries in remote control, see page 8.
2.
Connect signal, see below.
3.
Plug in AC power cord.
4.
Press POWER key to turn on TV.
5. Follow on-screen instructions, see pages 13~16.
VCR Back
Note:
If you do not have a VCR
connect signal directly to TV 75
ohm jack.
4
Basic Set-up and Connections
Operational Tip for No Signal Connection:
If the TV is used as a monitor only, with a DVD player or some other type of external
equipment, and no cable or antenna signal is available, the following condition will occur:
– Your TV is designed to automatically search for available channels. Therefore, the
initial start up requires that you press the MENU key, enabling the TV to automatically
go through the channel search process before you can operate the TV. After the initial
channel search is completed, you must press the MENU key again to complete the
channel search process. This may take several minutes.
– After the channel search process is complete (2 searches), you can press the INPUT
key on the remote control to use the TV as a monitor.
Basic Set-up and Connections
Note:
If you do not
have a cable box
connect cable
directly to TV 75
ohm jack or VCR.