Filter
Top Products
52
Antitheft Alarm Function
How to install the battery
To use the Antitheft alarm function, you need to install a
battery into the projector. (Use a SANYO Electric Co., Ltd.
CR2 3V lithium battery.)
Unplug the AC power cord from a wall outlet before
installing the battery. Remove the screw and open the
battery cover on the bottom of the projector.
When the battery is installed properly, the ALARM indicator
blinks for about 10 seconds. After placing the battery, put
the cover back and secure it with the screw.
When the battery comes to the end of its life, the ALARM
indicator flashes and the warning sound is produced at
some intervals.
Replace the battery by following the procedures above.
✔Notes:
•The PIN code and settings you have changed are effective even
after the battery is changed.
•When changing the battery, set the Antitheft alarm function to
“Off.” Otherwise the alarm starts ringing as you try to open the
battery cover.
Loosen the screw and
open the battery cover.
Install the battery, then put back the
battery cover and secure it with the
screw.