Sanyo PLV-55WHD1 Projection Television User Manual


 
18
PRECAUTIONS
To ensure safe operation, please observe the
following precautions:
Use two (2) AAA alkaline batteries, see page 8.
Replace both batteries at the same time. Do not
use a new battery with a used battery.
Risk of explosion, if battery is replaced by an
incorrect type.
If batteries have leaked in the remote control,
carefully wipe the case clean and load new
batteries.
Do not expose the remote control to moisture
or heat.
REMOTE CONTROL KEYS
q
INPUT KeyPress to change the input signal source
as follows: Analog RF Digital RF Video1
Video2 Video3 HDMI Analog RF.
w
NUMBER KeysTwo keys must be pressed to
select a direct channel. Example: Press 0 then 6 to
select channel 6.
For Analog Cable channels above 100, press and
hold the 1 key until C1- - appears, then press the
other two numbers.
e
INFO KeyPress to display the Digital and Analog
Full Banner information (press again to remove the
display).
Digital Full Banner display—Contains a two-part
Channel Number (Major and Minor), and Tuner ID. If
available, the following is also included: Station ID, V-
Chip Program Rating, Program Title, Audio Info, and
Signal Strength.
Tuner ID
Channel
Major Minor
Station ID
Program Rating
Signal StrengthAudio InfoProgram Title
Analog Full Banner display—Contains the Channel
Number (analog antenna/cable), Tuner ID, Station ID
(if available), Program Title (if available), V-Chip
Program Rating, and Audio Info.
Tuner ID Channel No. Station ID Program Rating
Program TitleAudio Info
Point toward
LCD Projection TV
q
w
e
r
t
u
i
o
!1
!2
!3
!4
!8
!5
!6
!7
y
!0
USING THE REMOTE CONTROL