Filter
Top Products
2
Installation
Connect the computer's monitor output
terminal to the projector's input terminal with
the VGA cable.
30°
30°
Connect the Presentation Remote Receiver to
the USB port of your computer.
1
2
VGA cable
Presentation
Remote Receiver
Presentation
Remote Control
16.4’(5 m)
Note :
– The Presentation Remote Receiver can only be connected
with a standard USB port.
– Some computer settings may have to be changed in order
for the mouse function to be used. Refer to your
computer's owner's manual for details.
– When switching the remote control code of the projector
and the remote control, that of the presentation remote
control also needs to be switched. Press and hold both
the FREEZE and P-TIMER buttons together for 10 seconds
or more to switch the code. (For detail, refer to the
projector owner's manual.)
Presentation Remote
Receiver and Projector
Remote Receiver.
To insure safe operation, please observe the following precautions :
● Use (2) AAA, SUM-4 or LR03 type alkaline batteries.
● Replace two batteries at the same time.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture, or heat.
● Do not drop the remote control.
● If a battery has leaked on remote control, carefully wipe case clean and install new batteries.
● Risk of explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
Remove the battery
compartment lid.
Slide the batteries into
the compartment.
Replace the compartment
lid.
Two AAA size batteries
For correct polarity (+ and
–), be sure battery terminals
are in contact with pins in
compartment.
12 3
Remote Control Battery Installation
Install the batteries into the Remote Control
with following the instruction below.
3
Note : Read carefully the battery precautions in the projector owner's manual.
English