Filter
Top Products
LASER POINTER FUNCTION
REMOTE CONTROL BATTERY INSTALLATION
Specifications are subject to change without notice.
TECHNICAL SPECIFICATIONS
AAA, SUM-4 or LR03 Type x 2
Power Source
16.4’ (5m) / ±30˚
Operating Range
1.8” x 1.0” x 5.7” (45mm x 25mm x 145mm)
Dimensions
0.22 lbs (99 g) (including batteries)
Net Weight
Class II Laser (Max. Output : 1m W / Wave length : 640-660nm)
Laser Pointer
This remote control emits a laser beam from the Laser Light Window. With the LASER button pressed, the laser light goes
on. The signal emission indicator lights red and the laser is emitted with red light. With the LASER button pressed for more
than 1 minute or released, the light goes off.
To lock this function, press both the MENU button and the NO SHOW button for more than 10 seconds. To unlock, press
the MENU button and NO SHOW button again for more than 10 seconds.
The laser emitted is a class II laser. Do not look into the laser light window or shine the laser beam on yourself or other
people. The caution labels for laser beam are shown below.
CAUTION : Use of controls, adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure. Do not look into the Laser Light Window while the laser is emitted, otherwise
eye damage may result.
Laser Light Window
The caution label is put on the remote control.
Signal Emission Indicator
To insure safe operation, please observe the following precautions :
● Use (2) AAA, SUM-4 or LR03 type alkaline batteries.
● Replace two batteries at the same time.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture, or heat.
● Do not drop the remote control.
● If battery solution has leaked in the battery compartment, carefully wipe the compartment clean and install
new batteries.
● Risk of explosion if the battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
Press the lid downward
and slide it.
Remove the battery
compartment lid.
Slide the batteries into
the compartment.
Replace the compartment lid.
Two AAA size batteries
For correct polarity (+ and
–), be sure battery
terminals are in contact
with pins in compartment.
1
2
3
4
English