Sanyo SRT-2400 VCR User Manual


 
OUTPUT TERMINALS
WARNING OUT Terminal
If the tape stops or other problem, the output becomes
0V (Low).
To reset the output, press the STOP or ALL RESET
button or unplug the power cord then plug it back in.
WARNING OUT Terminal Output Setting
1 Press the MENU button until the (SET UP 5) menu is
displayed.
@@@@@@@<SET@UP@5>
*INPUT@OUTPUT@ALARM
*OUTPUT@@@@@@@SERIES
*WARN.@OUT@@@@TRANSPORT
*REMOTE@@@@@@@EJECT
*TAPE@@@@@@@@@T-160
2 Press the ] button, until the “WARN. OUT” setting is
flashing.
3 Press the l (or j) button, to select the desired
output mode.
TRANSPORT. The output becomes 0V (Low)
when the tape stops or other
probrem with the internal
mechanism.
V. LOSS. . . . . The output becomes 0V (Low)
when there is no video signal
(Please refer to page 21, “Action
to Take when the Video Signal
Deteriorates.”).
T OR V. . . . . . The output become 0V (Low)
when the tape stops or other
problem with the internal
mechanism, or when there is no
video signal (Please refer to page
21, “Action to Take when the
Video Signal Deteriorates.”).
NOTE:
If in the (SET UP 4) menu “VIDEO LOSS” is set to
“N”, the “WARN. OUT” setting will be preset to
“TRANSPORT” and cannot be changed.
4 Press the PAUSE/SEARCH button to save the setting.
Tape movement stop
5V (H)
0V (L)
(Output impedance: 5.7 k)
Output reset
NU4QR/NA (SRT-2400 GB) Thu. Sept., 21/2000
English
43