Sanyo TLS-9072 VCR User Manual


 
RECORDING USING AN EXTERNAL TIMER
INPUT
Recording can be controlled by an external start/stop
signal input at the EXT TIMER IN terminal.
Example 3: To record using the signal input at the
EXT TIMER IN terminal, in 24-hour
mode.
X Follow the Before starting steps, under “NORMAL
RECORDING”.
NOTE:
X External timer input recording can only be set on the
9th line (EXT) of the (TIMER SET) menu.
1 Press the MENU button until the (TIMER SET) menu
is displayed.
2 Press the * (or +) button, until the “SPD” (recording
speed) position of the “EXT” line starts flashing.
3 Press the l (or j) button to select the recording
speed mode (ex: 24), then press the * button.
ø
“N” will start flashing.
4 Press the l (or j) button to select “Y”.
@@@@@@<TIMER@SET>
WEEK@START@@STOP@@@SPD
SUN@@--:--@@--:--@@---@N
MON@@--:--@@--:--@@---@N
TUE@@--:--@@--:--@@---@N
WED@@--:--@@--:--@@---@N
THU@@--:--@@--:--@@---@N
FRI@@--:--@@--:--@@---@N
SAT@@--:--@@--:--@@---@N
DLY@@--:--@@--:--@@---@N
EXT@@*****@@*****@@@24@Y
5 Follow steps F and G under “PROGRAM TIMER
RECORDING on page 23”.
ø
When an external signal is input, “E” will light on
the digital display and recording will take place.
NOTES:
X Other timer recordings using the standard procedure
can also be programmed.
X The external input signal must be input at the EXT
TIMER IN terminal.
RC4Q/NA2 (TLS-9072 GB) Thu. Sept., 07/2000
English 27