Filter
Top Products
SINGLE IMAGE RECORDING
The single image recording function of this VCR can be
used to create image data files or animations.
Single Image Recording Setup
1 In stop mode, press the REC/PLAY SPEED l (or j)
button, to set the recording speed to “0 00”.
2 Press the MENU button until the (SET UP 4) menu is
displayed.
@@@@@@@@<SET@UP@4>
öSW@OUT
@@FIELD@@@@@@@@@01
@@TIMING@@@@@@@@FIELD
@@2H@@@@@@@@@@@@Y
öTHREAD@CHECK@@@Y
öVIDEO@LOSS@@@@@N
öREC@SPEED@@@@@@N
ö1@SHOT@SET
@@FIELD@@@@@@@@@1
@@INTERVAL@@@@@@1M
3 Turn the JOG dial, until the “FIELD” setting is flashing.
4 Turn the SHUTTLE ring, to set the number of fields
(images) to record every time.
5 Turn the JOG dial, until the “INTERVAL” setting is
flashing.
6 Turn the SHUTTLE ring, to set the interval between
each image recording.
7 Press the SEARCH/AUDIO ON button to save the
settings.
8 Press the REC button.
ø
The single image recording mode will be
activated (the VCR will be in recording stand-by
mode).
9 Press the REC button one more time, or send a
trigger through the 1 SHOT IN terminal on the back
panel, to start the single image recording.
NOTE:
œ If at step 4, a setting other than “1” is selected for
“FIELD”, recording will be done in 120-hour mode.
The recording speed cannot be modified.
F When finished, press the STOP button.
NOTES:
œ The trigger at the 1 SHOT IN terminal should be on for
0.1 sec. or more.
œ The trigger interval at the 1 SHOT IN terminal varies
according to the number of images to record, but
should be over 1 sec.
œ To do alarm recording while in single image recording
mode, display the (SET UP 3) menu and set “SERIES
REC IN” to “N”.
œ If a single image recording trigger is not received (or if
the REC button is not pressed) during the duration set
for “INTERVAL”, single image recording will be
conducted automatically after the set duration.
œ If a single image recording trigger is received (or if the
REC button is pressed) during the duration set for
“INTERVAL”, single image recording will be conducted
immediately.
œ When using the 1 SHOT IN terminal, connect a
make-contact switch (no voltage) between the 1 SHOT
IN and COM terminals.
Alarm trigger while in single image
recording mode
If both alarm recording and single image recording modes
are set, alarm recording will be conducted as indicated
below.
œ If an alarm trigger is received while in single image
recording mode, alarm recording will be conducted in
2-hour recording mode then single image recording
mode will continue.
NOTE:
œ During single image recording mode, alarm recording
can only be conducted in 2-hour recording mode.
12345103060
1M 2M 3M
Recording of set number of images
"INTERVAL" setting (1, 2 or 3 minutes)
Input of single
image recording
trigger
Input of single image
recording trigger
RC4Q/U (TLS-9960 GB) Mon. Aug., 23/1999
30 English