What’s On the Back Panel?
8
1 Cable In Connect the coaxial cable that delivers the signal
from your cable service provider.
2 Cable Out Connect a coaxial cable to Cable Out to send
analog audio and video signals to a
TV or VCR. These signals are standard-
definition TV (SDTV) video and stereo
audio.
3 Audio Out Connect RCA cables to Audio Out to send analog
(LEFT and RIGHT) audio signals (left and right) to a TV with stereo
outputs.
4 Video Out Connect to video input of TV or VCR.
5 Digital Audio Connect an RCA cable to send a digital audio signal
Out to a surround-sound receiver or other digital audio
device.
6 Secondary Video Connect to either a VCR for archiving saved content
and Audio Out from the 8300 DVR or connect to another set of
inputs (composite) on your TV.
7 S-Video Out Connect an S-Video cable to send an S-Video
signal (LEFT and RIGHT) to your TV or
VCR. This signal is standard definition but higher
quality than other SDTV connections.
8IR (This connector reserved for future use.)
9SATA Connect to an external Serial ATA (SATA) hard disk
drive for expanded recording capacity. Check with
your cable service provider for a list of approved
hard drive models for use with the 8300
DVR.
10 AC Outlet Connect the AC power cord from another device,
such as a TV.
11 AC Power Input Connect the power cord to deliver power to the 8300
DVR.
IR
CABLE
OUT
THIS DEVICE IS INTENDED TO BE ATTACHED
TO A RECEIVER THAT IS NOT USED TO
RECEIVE OVER-THE-AIR BROADCAST
SIGNALS. CONNECTION OF THIS DEVICE
IN ANY OTHER FASHION MAY CAUSE
HARMFUL INTERFERENCE TO RADIO
COMMUNICATIONS AND IS IN VIOLATION
OF THE FCC RULES, PART 15.
120 VAC
60HZ 5A
LISTED 14H1
CABLE EQUIP.
120 VAC
60HZ 80W
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CABLE
IN
SATA
S - VIDEO
OUT
CATV CONVERTER
MADE IN MEXICO
VIDEOVIDEO
TV
OUT 1 OUT 2
A
U
D
I
O
DIGITAL
AUDIO OUT
L
R
AVIS:
RISQUE DE CHOC
ELECTRIQUE NE PAS OUVRIR
1 75 64 98 10 1132
T11274
