Filter
Top Products
15
Use Power-Save Mode
To maximize the life of your DVR, you should power-down the DVR when it is
not in use. Simply press CBL and then Power on your remote control, or press
Power on the front panel of the DVR. The Power light turns off; but, because the
DVR is still plugged in, your scheduled recordings still occur.
Between 1:00 a.m. and 6:00 a.m. daily, your DVR
will automatically enter Power-Save mode unless
you press a key on the remote control or a key on
the DVR front panel at least once every 2 hours. In
Power-Save mode, the set-top is powered-down,
but all scheduled recordings still occur. When the
DVR enters Power-Save mode, your TV displays a
black screen. Note: Your cable service provider
controls whether or not the automatic Power-Save
mode is activated on your set-top.
At 1:10 a.m., the DVR displays the above 5-minute warning banner, indicating
that the DVR is about to enter power-save mode. When this banner appears, do
one of the following:
• To allow the DVR to enter Power-Save mode, do nothing when the warning
banner appears. The DVR will automatically power-down. After your DVR
powers down, you must press CBL and then Power on your remote control,
or press Power on the front panel of your DVR to start watching TV again.
• To prevent the DVR from entering Power-Save mode, simply press any key
on your remote or any key on the front panel of the DVR when the warning
banner appears. The DVR will not attempt to enter power-save mode again
until another 2 hours of inactivity has passed.
Attention
Your DVR will automatically enter power-save mode in 5 minutes.
Press any remote key to continue watching TV.