Filter
Top Products
8
LC-26DV27UT
LC-32DV27UT
OPERATION MANUAL
MODE D’EMPLOI
MANUAL DE OPERACIÓN
COMBINATION LIQUID CRYSTAL TELEVISION
AND DVD/CD PLAYER
COMBINÉ TÉLÉVISEUR ACL ET LECTEUR DVD/CD
COMBINACION TELEVISOR CON PANTALLA DE
CRISTAL LÍQUIDO CON DVD/DISCOS COMPACTOS
ESPAÑOL FRANÇAIS ENGLISH
IMPORTANT : Please read this operation manual before starting operating the equipment.
IMPORTANT : Veuillez lire ce mode d'emploi avant de commencer à utiliser l'appareil.
IMPORTANTE : Lea este manual de operación antes de comenzar a operar el equipo.
(Illustration is LC-26DV27UT.) (Illustration is LC-32DV27UT.)
Remote control unit
(X1)
Page 10
“AA” size battery
(X2)
Page 10
AC cord (X1)
Page 9
Cable Tie (X1)
Page 9
Stand unit (X1)
Page 8
Operation manual
(X1)
NOTE
• Always use the AC cord supplied with the TV/DVD.
Supplied accessories
Make sure the following accessories are provided with the product.
To avoid scratching the frame or screen, please use a soft, lint free cloth for cleaning. Approved cleaning cloths are
available directly from Sharp in single (00Z-LCD-CLOTH) or triple (00Z-LCD- CLOTH- 3) packs. Call 1-800-BE-SHARP
for ordering, or VISIT www.sharpusa.com/SharpDirect.
QUICK REFERENCE
Attaching the stand
Ventilation & Cleaning Tips
Keep your TV/DVD in a well ventilated area and make sure not to place it by a heat source or use near
water. The TV/DVD is designed for AC use only and should be used with supplied AC cord.
Clean the screen by spraying a soft lint free cloth with water to lightly moisten.
Gently wipe and avoid pressing on the screen. To clean the outer cabinet, use the same method.
Do not use liquid or aerosol cleaners.
The screen is glass and can be scratched or broken when dropped or impacted.
Before attaching (or detaching) the stand, unplug the AC cord from the AC input terminal.
Before performing work spread cushioning over the base area to lay the TV/DVD on. This will prevent it from being damaged.
•
•
CAUTION
Attach the stand in the correct direction.
Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
•
•
1
Confirm the 8 screws supplied with the TV/DVD.
Short screws (
X4)
(used in step 2)
Long screws (X4)
(used in step 3)
2
Remove the covering sheet of the stand.
1
Attach the base to the post.
2
Attach the base to the 4 screws into the 4 holes on the
bottom of the base.
Hex key
Screw
3
1
Insert the stand into the openings on the bottom of the
TV/DVD.
2
Insert and tighten the 4 screws into the 4 holes on the
rear of the TV/DVD.
Soft cushion
Hex key
Screw
4
For protection, sheets
are covering the product.
Please remove these
sheets before use.
NOTE
• To detach the stand, perform the step in reverse order.
(Illustration is LC-26DV27UT.)
52L0131B.indb 852L0131B.indb 8 6/24/09 1:41:51 PM6/24/09 1:41:51 PM