Sharp AQUOS LC-57D90U Flat Panel Television User Manual


 
17
Changing channels-Air/Cable
You can change channels in several ways by pressing
AIR or CABLE to select the antenna and then following
one of the methods below.
Method 1
Using CHr/s on the remote control unit or on the TV.
Method 2
1. Press FLASHBACK to switch to the previously tuned
channel.
2. Press FLASHBACK again to switch back to the
currently tuned channel.
NOTE
FLASHBACK will not work if no channel has been
changed after the TV is turned on.
Method 3
Using remote control buttons 0–9, (DOT) to select
channels for VHF/UHF/CATV/DIGITAL.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press 5s ENT
NOTE
When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
When you enter 09 only, channel selection will be made
if there is no operation within a few seconds.
To select a 3-digit channel number
(e. g., Channel 115):
Press 1s1s5
NOTE
When you enter 09 only, channel selection will be made
if there is no operation within a few seconds.
If you push “0” by itself, nothing will happen.
Complete the above steps within a few seconds.
When you enter 09 and • (DOT), channel selection will
be made if there is no operation within a few seconds.
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2 s2s• (DOT) s1s ENT
5
Air
5
Air ANALOG
11
Cable
1
Cable
115
Cable ANALOG
22.
Air Air DIGITAL
22.1
22.1
Air
22
Air
2
Air
Watching TV
LC-57D90U(E)-017-020 06.1.12, 2:40 PM17
Black