Filter
Top Products
3
Attaching the stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC outlet.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
1
Confi rm the screws supplied with the TV.
1
2
Soft cushion
Screw
Screw
Screw driver
Screw driver
Screws (
m
8)
(used in step 2 and 3)
2
Attach the stand neck to the stand base,
insert and tighten the 4 screws into the 4
holes on the bottom of the stand base (
1
).
3
Attach the stand neck to rear of the TV,
insert and tighten the 4 screws into the 4
holes on the stand neck. (
2
)
NOTE
•
To detach the stand, perform the steps in reverse
order.
Setting the TV
Connecting the antenna cable
To enjoy a clearer picture, use an outdoor antenna.
VHF/UHF
antenna
or
VHF/UHF
antenna
300-ohm twin-
lead fl at feeder
(not supplied)
75-ohm
impedance
converter
(not supplied)
Standard DIN45325
plug (IEC 169-2)
75-ohm coaxial
cable (round cable)
(not supplied)
To antenna terminal
If your outdoor antenna uses a 75-ohm coaxial
cable with a standard DIN45325 plug (IEC 169-2),
plug it into the antenna jack at the rear of the set.
If your outdoor antenna uses a 300-ohm twin-
lead fl at feeder, connect a 300-ohm to 75-ohm
impedance converter and plug it into the antenna
jack at the rear of the set.
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
AC CORD CONNECTED.
• The illustrations used throughout this manual are based on LC-32LE430X.
LC24LE430X_EN.indb 3LC24LE430X_EN.indb 3 7/19/2011 9:38:05 AM7/19/2011 9:38:05 AM