Sharp LC-46BD80U Flat Panel Television User Manual


 
23
Disc Playback
This section explains playback of commercially
available BD-VIDEO and DVD-VIDEO discs (like
movies), CDs, and recorded DVD-RW/R discs.
Loading a Disc
Insert the disc into the disc slot.
The label side of the disc must face towards the front of the
TV (towards you).
When inserting a dual-sided DVD, the side you want to play
must face towards the rear of the TV (away from you).
When the disc is loaded, the DISC indicator lights up.
Playback may begin automatically, depending on the disc.
The menu may be displayed fi rst, depending on the disc.
Perform playback operation by following the directions on
the screen.
In the following cases, the disc will be ejected
automatically.
- When a disc using an incompatible standard or format
was inserted.
- When the disc was inserted facing the wrong way.
Removing a Disc
1
Press on the TV or EJECT on the remote control
unit.
(EJECT)
button
The disc is ejected and protrudes partly from the slot.
2
Carefully grasp the protruding disc and pull it out.
After a disc has been ejected, it should be removed
from the slot without delay.
If the TV is jolted or moved while a disc is protruding from
the slot, the disc may fall out.
To reinsert a protruding disc, fi rst remove the disc fully and
then load it again.
During loading, the disc may be unable to be ejected. Wait
until the loading is complete and playback starts to eject
the disc.
BD/DVD-VIDEO Playback
BD-VIDEO
DVD-VIDEO
BD-RE
BD-R
1
Load a disc.
Playback may begin automatically, depending on the
disc.
2
Press
d
.
Playback begins from the fi rst title.
The menu may be displayed fi rst, depending on the
disc. Perform playback operation by following the
directions on the screen.
The disc load time may vary depending on the disc.
During playback of HDMI equipment connected to the TV
with AQUOS LINK Control set to “Enable”, pressing d
controls the HDMI equipment, not the Disc Drive on the TV.
Playback on the Disc Drive will stop when you switch the
input source or select a TV channel.
To stop playback
Press
H
.
Resume playback function
After stopping the disc, press
d
to resume playback
from the point where the disc has been stopped.
To play back from the beginning of the disc, press
H
twice
and then press
d
.
(This may not work depending on the
type of disc. In this case, eject the disc or enter standby.)
Resume playback may not function depending on the disc.
Disc slot
The label side of
the disc