Filter
Top Products
Supplied accessories
QUICK REFERENCE
2
1 3
22
1
Hex key
Long
screw
Soft cushion
6
2
2
3
3
1
1
Hex key
Short screw
1
Insert the stand into the openings on the
bottom of the TV.
2
Insert and tighten the 4 long screws into
the 4 holes on the rear of the TV.
NOTE
• To detach the stand, perform the steps in reverse order.
Attach the two supporting posts for the stand
unit onto the base using the box for the stand
unit as shown below.
(Close-up of the upper side of the stand unit)
Confi rm that there are 10 screws (6 short
screws and 4 long screws) supplied with the TV.
Attaching the stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
•
Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
NOTE
• Always use the AC cord supplied with the TV.
• AC cord enclosed in this product is for 110-125V. In using it on the 125-240V AC, please consult to the following.
SHARP ELECTRONICS CORPORATION
6100 Blue Lagoon Drive, Suite 230, Miami, Florida 33126, U.S.A.
Make sure the following accessories are provided with the product.
Remote control unit
(
g
1)
Page 8
“AAA” size battery
(
g
2)
Page 8
AC cord
(
g
1)
Page 7
Stand unit
(
g
1)
Page 6
Cable clamp (
g
2)
Cable tie (
g
1)
Page 7
Operation manual
(
g
1)
1 Insert each of the protrusions on the two
supporting posts into the openings on the
upper side of the base.
2 Insert and tighten the 6 short screws with
the hex key (supplied with the product) in the
order of
1
,
2
and
3
.